Eiki LC-XT2 instruction manual Connecting To Computer, Audio Speaker, stereo, Terminal

CONNECTING PROJECTOR

CONNECTING TO COMPUTER

Cables used for connection (✽ = Cables are not supplied with this projector.)

•VGA Cable (HDB 15 pin)

•Control Cable for PS/2 port, Serial port, or ADB port

•MAC/VGA Adapter, DVI/VGA Adapter

•DVI Cable

•BNC Cable (BNC x 5) ✽

•Audio Cables (RCA x 2) ✽

NOTE :

When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on.

IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA / SXGA/UXGA)

Desktop type

Laptop type

Monitor Output Monitor Output Monitor Output Audio Output Serial port PS/2 port ADB port

MAC/VGA

Adapter

Set slide switches

following chart

below.

			Control Cable Control Cable		Control Cable
	DVI Cable	Audio Cable	for Serial Port	for PS/2 Port	for ADB Port
BNC Cable ✽			Terminal	Terminal	Terminal
		(stereo) ✽
VGA Cable	DVI/VGA Adapter

Use one of these Control Cables corresponding with terminal of your computer.

Terminals of

a Projector

SERIAL PORT IN				DVI			AUDIO	L	CONTROL PORT
							R
							(MONO)
SERIAL PORT OUT		R/Pr	G/Y	B/Pb	H/HV	V	AUDIO		CONTROL PORT
							R	L
							(MONO)
R/C JACK	USB	VIDEO/Y	C		S-VIDEO		AUDIO
							R	L
							(MONO)
AUDIO OUT							AUDIO		CONTROL PORT
R	L		ANALOG RGB
							R	L
	RESET
	(MONO)						(MONO)

INPUT 4 INPUT 3 INPUT 2 INPUT 1

AUDIO OUT

Audio Cable (stereo) ✽

Audio Input

External Audio Equipment

Audio Amplifier	Audio Speaker
		(stereo)

	MAC/VGA ADAPTER
Switches of	ON
	ON DIP
MAC/VGA Adapter	1 2 3 4 5 6

OFF

Set switches as shown in table below depending on RESOLUTION MODE that you want to use before your turn on a projector and computer

MODE	SWITCHES	1	2	3	4	5	6
13"MODE (640 x 480)		ON	ON	OFF	OFF	OFF	OFF
16"MODE (832 x 624)		OFF	ON	OFF	ON	OFF	OFF
19"MODE (1024 x768)		OFF	ON	ON	OFF	OFF	OFF
21"MODE (1152 x 870)		ON	ON	ON	ON	OFF	OFF

14