E
13
1 INSTALLATION

Macintosh

You must connect an optional Macintosh adapter to the PC before
connecting the signal cable.
5) Turn on the monitor power first, then switch on the PC power. The
monitor’s power indicator (LED) will light up (green). The monitor will
warm up briefly, then display an image. Whenever you finish your
operation, turn off the PC and the monitor.
• If an image does not appear, make sure that all connections have been
made properly. Refer to the “TROUBLESHOOTING” section on page
36 for additional advice.
1-3 Setting the resolution
The following look-up table shows the maximum (Non-interlaced) vertical
refresh rates for this model with regard to standard resolutions set forth by
VESA. The best way to see if the monitor will work with a given resolu-
tion and rate, is to compare the vertical refresh rate of the graphics board
to the monitor’s range (Refer to the graphics board manual for specifica-
tions). If the refresh rate is within the specified range of the monitor, it
should operate properly.
Maximum Vertical Refresh rate (Hz)
640x480 800x600 1024x768 1280x1024 1600x1200
30-96 160 144 118 89 76
D-Sub
mini 15 pin
D-Sub
mini 15 pin
MD-C87 (enclosed)
D-Sub 15 pin
Macintosh Adapter (Optional)
Macintosh
Horizontal Scan
Frequency (kHz)