34 2 SCREEN ADJUSTMENT
In the case of only one signal being present at either input, the monitor
automatically detects and displays that signal.
Priority setting Performance
If signals from both inputs are present, the monitor
gives preference to D-Sub for the cases shown below:
•When the power of the monitor is turned ON (see
note 1).
•When the signal input to D-Sub is changed even if
active input was BNC.
If signals from both inputs are present, the monitor
gives preference to BNC for the cases shown below:
•When the power of the monitor is turned ON (see
note 1).
•When the signal input to BNC is changed even if
active input was D-Sub.
The monitor will not detect signals automatically in
this mode. Select the active input by pressing the
input signal selection button on the monitor’s front
panel.
1 The Input Priority function does not automatically reactivate when the
monitor has been in the power save mode.
2 The Input selection button on the front panel can be used to select
either D-Sub or BNC as the active input at any time.
Beep
Use this feature to set the beeper ON or OFF. If the beeper is ON, the
monitor will generate beep signals as shown below. If the beeper is OFF,
the monitor will not beep.
Short beep • ScreenManager item selected.
• ScreenManager parameter adjusted to minimum
or maximum limit.
• BNC/D-Sub selection button pressed.
Long beep • AUTO-SIZING button pressed.
• ScreenManager data-save executed.
Four short beeps • Monitor not connected correctly.
• PC turned off.
• Monitor received unsupported signal frequency.
D-Sub
BNC
Manual