2. Plug the power cord into the power connector at the rear of the monitor. Then plug the other end of the cord into a power outlet.

WARNING

•The equipment must be connected to a grounded main

outlet.

•Use the enclosed power cord. If using the power cord other than the enclosed one, use the following cord.

[USA and Canada]

Use a UL LISTED/CSA LABELED or CERTIFIED power cord set meeting the following specifications:

*Rating: min. 125 V, 10 A

*Length: max.2.0 m

*Type: SVT

*Plug type: NEMA 5-15P, Parallel blade,

Grounding type, 125 V, 10 A

[Europe]

Use a proper European standard approved power cord meeting the following specifications:

*

Rating:

min. 250 V, 10 A

*

Length:

max. 2.0 m

* Type:

H05VV-F 3G 1 mm2

Use a plug type approved by the country where you reside.

Failure to do so may cause fire or electric shock.

3. Turn on the monitor first, then the PC.

The monitor’s power indicator will light up (green). The monitor will warm up briefly, then display an image. Whenever finishing your operation, turn off the PC and the monitor.

(If an image does not appear, make sure that all connections have been made properly. Refer to the “TROUBLE SHOOTING”(See page 22) for additional advice.)

• Generally, for maximum viewing comfort, position the monitor slightly below eye level. Staring at the monitor for prolonged periods can cause eye strain. Be sure to take adequate rests.

(A 10-minute rest period each hour is suggested.)

12 2. INSTALLATION