English

6. TROUBLESHOOTING

If a problem persists even after applying the suggested remedies, contact an EIZO dealer. The latest FAQ information is supplied on EIZO homepage (http://www.eizo.com/).

ξ No Picture Problems

Problems

Points to check with possible solutions

1. No picture

† Check that the power cord is correctly

ξ Indicator status: Off

connected. If the problem persists, turn off the

monitor power for a few minutes, then turn it

 

 

back on and try again.

 

 

ξ Indicator status: Blue

† Check the “Brightness” setting.

 

† Switch the signal input by pressing the Input

 

Signal Selection Button on the front control

ξ Indicator status: Yellow Flashing

panel.

† Try pressing the power switch.

 

 

 

2. Following messages appear.

These message appear when the signal is not

(Error messages shown below will

inputted correctly, even if the monitor functions

remain on the screen for 40

properly.

seconds.)

† When the image is displayed correctly after a

 

short time, there is no problem with the

 

monitor. (Some PCs do not output the signal

 

soon after powering on.)

 

† Check that the PC is turned ON.

 

† Check that the signal cable is properly

 

connected to the PC or graphics board.

 

† Switch the signal input by pressing the Input

 

Signal Selection Button on the front control

 

panel.

ξ Whenever an error signal message

† Use the graphics board’s utility software to

appears, the signal frequency will be

change the frequency setting. (Refer to the

displayed in red.

manual of the graphics board.)

 

 

 

 

6. TROUBLESHOOTING 27