English
3. Lead the power cord and signal cable into the cable holder at rear of the monitor.
NOTE
•The cables are recommended to lead with slight sag for the smooth motion of the stand and the Portrait/Landscape display.
Cable Holder
4. Plug the other end of the power cord into a power outlet.
WARNING
Use the enclosed power cord and connect to the standard power outlet of your country.
Be sure to remain within the rated voltage of the power cord.
Not doing so may cause in fire or electric shock.
The equipment must be connected to a grounded main outlet.
Not doing so may cause in fire or electric shock. Not doing so may cause in fire or electric shock.
5. Turn on the monitor's power button and then switch on the PC's power.
The monitor’s power indicator will light up (green).
If an image does not appear, refer to the “TROUBLE SHOOTING” (p.36) for advice.
Whenever finished, turn off the PC and the monitor.
NOTE
•When turning on the monitor, the kind of the input signal (Signal1 or 2/Analog or Digital) is displayed for a few seconds on the right top corner of the screen.
•Adjust brightness of the screen depending on the brightness of your environment.
•Be sure to take adequate rests. A
14 2. CABLE CONNECTION