English

Selecting the Active Input

The Input signal selection button on the control panel can be used to select either Signal 1 or Signal 2 as the active input at any time. Every time the button is pressed, the input changes. When switching the signal, the kind of the input signal (Signal1/ Analog or Signal 2/Analog or Digital) is displayed for a few seconds on the right top corner of the screen.

Input Signal Selection Button

SIGNAL

1 - 2

NOTE

AUTO ENTER

When using the ActiveShot function (p. 31), pressing the Input signal selection button switches the image of the Main window and the Sub window.

The Priority Input Signal

This function is used to select which PC will have priority to control the monitor when utilizing two PCs. The monitor constantly checks the input signals and switches automatically in accordance with the “Input Priority” setting (see table below). Once a priority is set, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal.

In the case of only one signal being present at either input, the monitor automatically detects and displays that signal.

Priority

Performance

Setting

 

1

If signals from both inputs are present, the monitor gives preference to Signal

1 in the following cases.

(SIGNAL 1 –

When the power of the monitor is turned ON.

D-Sub mini

15 pin Input

When the signal input to Signal 1 is changed even if active input was Signal

Connector)

2.

 

2

If signals from both inputs are present, the monitor gives preference to Signal

2 in the following cases.

(SIGNAL 2 –

When the power of the monitor is turned ON.

DVI Input

When the signal input to Signal 2 is changed even if active input was Signal

Connector)

 

1.

 

The monitor will not detect signals automatically in this mode. Select the

Manual

active input by pressing the Input Signal Selection Button on the monitor’s

 

control panel.

 

 

NOTE

About Power saving mode

When the “1” or “2” is selected, the power saving mode of the monitor activates only if both PCs are in power saving mode.

16 2. CABLE CONNECTION