English

The Priority Input Signal

This function is used to select which PC will have priority to control the monitor when utilizing two PCs. The monitor constantly checks the input signals and switches automatically in accordance with the “Input Priority” setting (see table below). Once a priority is set, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal.

In the case of only one signal being present at either input, the monitor automatically detects and displays that signal.

Priority setting

Performance

 

If signals from both inputs are present, the monitor gives

1

preference to Signal 1 in the following cases.

When the power of the monitor is turned ON.

(SIGNAL 1 – DVI-I Input

Connector)

When the signal input to Signal 1 is changed even if active input

 

was Signal 2.

 

If signals from both inputs are present, the monitor gives

2

preference to Signal 2 in the following cases.

When the power of the monitor is turned ON.

(SIGNAL 2 – D-Sub mini

15 pin Input Connector)

When the signal input to Signal 2 is changed even if active input

 

was Signal 1.

 

The monitor will not detect signals automatically in this mode.

Manual

Select the active input by pressing the Input Signal Selection

 

Button on the monitor’s control panel.

 

 

NOTE

When the “1” or “2” is selected, the power saving mode of the monitor activates only if both PCs are in power saving mode.

2. CABLE CONNECTION 17