Eizo L985EX 6. TROUBLESHOOTING

English

6. TROUBLESHOOTING

If a problem persists even after applying the suggested remedies, contact an EIZO dealer.

•	No picture problems See No.1 ~ No.2
•	Imaging problems	See No.3 ~ No.14
•	Other problems	See No.15 ~ No.19
•	USB problems See No.20
	Problems		Points to check with Possible Solutions
1. No picture			† Check that the power cord is correctly connected.
• Indicator status: Off			If the problem persists, turn off the monitor power
			for a few minutes, then turn it back on and try
			again.
• Indicator status: Blue			† Check the “Brightness” setting.
• Indicator status: Yellow			† Switch the signal input by pressing the Input Signal
			Selection Button on the front control panel.
			† Try pressing a key on the keyboard, or clicking the
			mouse.
			(p.32)
• Indicator status: Slowly flashing			† Try pressing the Power Button.
Yellow
• Indicator status: Flashing Yellow			† Try turning the PC on.
(twice for each)
2. Error messages shown below will			These message appear when the signal is not inputted
remain on the screen for 40			correctly, even if the monitor functions properly.
seconds.			† When the image is displayed correctly after a short
			time, there is no problem with the monitor. (Some
			PCs do not output the signal soon after powering
			on.)
			† Check that the PC is turned ON.
			† Check that the signal cable is properly connected to
			the PC or graphics board.
			† Switch the signal input by pressing the Input Signal
			Selection Button on the front control panel.
• Whenever an error signal message			† Use the graphics board’s utility software to change
appears, the signal frequency will be			the frequency setting. (Refer to the manual of the
displayed in red.			graphics board.)
(Example)

36 6. TROUBLESHOOTING