34 Chapter 6 Reference
Chapter 6 Reference

6-1. Attaching an Arm

The stand can be removed and replaced with a n arm (or another stand) to be attached t o the monitor. Use
an arm or stand of EIZO option.
Attention
When attaching a n arm or stand, follow the inst ructions of their user’s manual.
When using another manu facturer’s arm or stand, co nrm the following in advan ce and select one conforming to
the VESA standard.
- Clearance between the sc rew holes: 100 mm × 100 mm
- Thickness of plate: 2.6 mm
- Strong enough to support weig ht of the monitor unit (except the stand) and att achments such as cables.
Use the screws as described below.
- SX2262W
The screws xing the sta nd to the monitor
- SX2462W
The screws supplied with thi s monitor (M4 × 12mm)
When using an arm or st and, attach it to meet the followi ng tilt angles of the monitor.
- Up 45 degrees, down 45 degrees (hori zontal display, and vertical display rotat ed 90 degrees clockwise)
Connect the cables after at taching an arm or a st and.
Do not adjust the height of the stand removed f rom the monitor. When adjusted w ithout attached monitor, it
causes the personnel inju ry or the damaged to the st and.
Since the monitor and arm or st and are so heavy, dropping them may r esult in injury or equipme nt damage.
If you need to remove the SX2262W, turn the panel on the mon itor to the left and right a little so t hat the four
screws positioned under the st and are visible. Then, unscr ew the four screws.
•
•
•
•
•
•
•

[Attachment Procedure]

1 Lay the LCD monitor on a soft cloth spread over on a stable surface with the

panel surface facing down.

2 Remove the stand.
Prepare a screwdriver. Unscrew the four screws secu ring the unit and the sta nd with the screwdriver.
3 Attach the monitor to the ar m or stand.
Secure the monitor to the arm or st and using the screws specied in the user’s manual of the ar m or stand.