Event MH™
©Elation Professional® 14 Event MH™
6. MOUNTING AND INSTALLATION Caution: For added protection mount the fixtures in areas outside of walking paths, seating
areas, or areas were the fixture might be reached by unauthorized personal.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
To avoid injury, never stand directly below the device when mounting, removing, or servicing
the fixture.
Refer to regulations BGV C1 (formerly VBG 70) and DIN VDE
0711-217 for proper installation in Europe
To ensure proper installation, only qualified staff should
attempt installation.
Mounting
The EVENT MH™ is fully operational in two different mounting positions, hanging
upside-down from a ceiling, or set on a flat level surface (see illustration on next page). To
avoid internal damage to the unit, never mount the unit on its side in a permanent
installation as illustrated on the next page. This could cause excessive stress on the motors
and damage the unit. Be sure this fixture is kept at least 0.5m away from any flammable
materials (decoration etc.). Always use and install the supplied safety cable as a safety
measure to prevent accidental damage and/or injury in the event the clamp fails.
Be sure to complete all rigging and installation procedures before connecting the main
power cord to the appropriate wall outlet.