Event MH™
©Elation Professional® 20 Event MH™
Note: During start-up the Event MH™ will automatically detect whether a DMX data signal is
being received or not. If DMX data signal is being received, the display will show "A.XXX"
(XXX representing the actual DMX address). If the fixture is not receiving a DMX signal the
display will flash "A.XXX" (XXX representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not receiving a
DMX signal), please check the following:
- The 3 PIN XLR plug (cable with DMX signal from controller) is not connected or is not
inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX chain.