©Elation Professional® 9 impression™
6. DMX Output Jack – This 3-Pin XLR jack is used to send an outgoing DMX signal.
For best results this jack should be terminated if it is the last fixture in a DMX
daisy-chain (see termination on page 19).
7. DMX Input Jack – This 3-Pin XLR jack is used to receive an incoming DMX signal.
8. Electronics Fuse Holder – This housing holds a 250v/4A GMA fuse (120v
operation). Never defeat this fuse, this fuse is designed to protect the electronics in
the event of severer power fluctuations. In the event of fuse failure, always be sure
to replace this fuse with an exact match unless otherwise instructed by an
authorized Elation technician.
9. Powercon Connector – This power jack is designed to be used only with the
Neutrik Powercon adapter included with your fixture. This jack provides main power
to your fixture.
10. Safety Cable Mounting Point Connection – The fixture includes two safety cable
slots intergraded into the base. Be sure to use these slots as a secondary rigging
point to secure the fixture in the event a clamp fails.