Electro-Voice CP2200, CP1800 manual Specifications

					SPECIFICATIONS
- Amplifier at rated conditions, both channels driven, 8Ω loads, unless otherwise specified.
				CP 2200
	Load Impedance	2Ω		4Ω		8Ω
	Maximum Midband Output Power	1100W		800W		500W
	THD = 1%, 1kHz, Dual Channel
	Rated Output Power	--		700W		350W
	THD < 0.1%, 20Hz ... 20kHz
	Max. Single Channel Output Power	2200W		1200W		625W
	IHF-A
	Max. Single Channel Output Power	1500W		950W		550W
	Continuous, 1kHz, THD-1%
	Max. Bridged Output Power	--		2200W		1600W
	THD = 1%, 1kHz
	Maximum RMS Voltage Swing			72V
	THD = 1%, 1kHz
	Power Bandwith			10Hz ... 60kHz
	THD = 1%, ref. 1kHz, half power @ 4Ω
	Voltage Gain			32,0 dB
	ref. 1kHz
	Input Sensitivity		+4.7 dBu (1.33V rms)
	at rated output power
	THD at rated output power,		< 0.05%
	MBW = 80kHz, 1kHz
	IMD-SMPTE		< 0.02%
	60Hz, 7kHz
	DIM30		< 0.01%
	3.15kHz, 15kHz
	Maximum Input Level			+22dBu (9.76 Vrms)
	Crosstalk			<- 80dB
	ref. 1kHz, at rated output power
	Frequency Response			15Hz ... 40kHz
	-1dB, ref. 1kHz
	Damping Factor		> 300
	1kHz
	Slew Rate			35 V/ms
	Signal to Noise Ratio, Amplifier			107dB
	A-weighted
	Output Stage Topology			Class H
	Power Requirements	240, 230, 120V or 100V; 50 ... 60 Hz (factory configured)
	Power Consumption			660W
	1/8 maximum output power @ 4Ω
	Protection	Audio limiters, High temperature, DC, HF, Back-EMF,
		Peak current limiters, Inrush current limiters, Turn-on delay
	Cooling		Front-to rear, 3stage-fans
	Safety Class			I
	Dimensions			483 x 88,1 x 386,8
	(W x H x D), mm
	Weight			16 kg (35.2 Ibs)
	Optional	Rear-rackmount 15,5“ (NRS 90262) 112930
		Rear-rackmount 18“ (NRS 90264) 112933

-Depending on the ambient temperature, the unit might not operate continuously at 2 ohms load in Dual Mode or 4 ohms load in Bridged Mode.