Electro-Voice SxA100+ owner manual Using Two-Way SxA Systems as Floor Monitors

Using Two-Way SxA Systems as Floor Monitors

SxA two-way systems are perfect for use as powered floor monitors.

The correct projection angle is already incorporated into the enclosure design of the SxA250. Simply turn the SxA250 on its side and operate the system in the same manner as described above. The F200 adapters are necessary to convert the SxA100+ into a monitor and are shipped with the speaker. To install the adapters, simply insert them into the speaker (See Figure 8 below). The F200 adapters can be easily removed by pulling in the opposite direction.

The F200 Monitor Foot kit contains two plastic feet.

The F200 is used with any 12-inch Sx or SxA speaker enclosures. Insert the feet firmly into the holes in the rear cabinet (See Figure 8). Remove the F200 monitor feet by pulling in the opposite direction.

“O” RING	MONITOR
LOCATION	FOOT

PERMANENT SCREW

LOCATION

FIGURE 8:

Installing the F200 Monitor Foot on SxA100+ Speaker

CAUTION: The F200 monitor feet protrude from the enclosure. Care should be taken when moving the enclosure, since damage to the feet or enclosure might occur if the system is dropped or slid across a rough surface. It is recommended that the feet be removed for transport.

11	ELECTRO-VOICE		Owner’s Manual
		®	Owner’s Manual
		®