Installation
Water inlet (cold water connection only)
Connect the hose to a tap with a 3/4” thread.
Installation should comply with local
water authority and building regulations’ requirements.
Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to nat- ural ageing of the hose. This fault is shown by a red sector in the window “A”. Should this occur, turn
the water tap off and refer to your Service Force A Centre to replace the hose.
Water drainage
TThis appliance is designed to be perma- nently plumbed into your home's drainage system using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
Place the drain hose into your standpipe, which should have an internal diameter of approx- imately 38mm thus ensuring there is an air break between the drain hose and standpipe.
P1074
“U” piece supplied
P1199
38 mm (11.2”)
standpipe diameter
30 cm (12")
52
