Electrolux 137023200 A manual Setting Preferences, con’t, Install Cycle

Models: 137023200 A

1 44
Download 44 pages 48.14 Kb
Page 29
Image 29
Setting Preferences, con’t

Operating User Interface Features 29

Setting Preferences, con’t

INSTALL CYCLE

Run the INSTALL CYCLE before operating the washer the first time. Remove all items from the washer drum and press start. For more informa- tion on performing the washer INSTALL CYCLE, refer to the Installation Instructions accompanying this washer.

If the washer has been installed according to Installation Instructions, INSTALL PASSED - DOOR CAN BE OPENED will be displayed and the washer is ready to use.

If the washer was not installed properly, NO WATER -

OPEN WATER VALVES, WATER HOSES - CHECK WATER HOSES or CALL SERVICE 877 435 3287 will be displayed to indicate the installation

error.

The errors may result from the following condi- tions:

NO WATER —Water inlet hoses have not been attached to water supply or water supply valves have not been turned on. Install hoses correctly and turn on water supply valves.

CHECK HOSES —The hot inlet hose may have been connected to the cold water supply and the cold inlet hose may have been connected to the hot water supply. Check hoses for cor- rect supply connection. If incorrect, disconnect hoses and connect to correct inlets according to Installation Instructions.

CALL SERVICE 877 435 3287—Error can only be corrected by calling a qualified techni- cian (1-877-435-3287).

Repeat the INSTALL CYCLE when corrections are completed.

NOTE

The INSTALL CYCLE is prompted automatically only once when the washer is turned on the first time at the end of installation. After that, if you wish to run a subsequent INSTALL CYCLE when moving the washer or modifying your installation, you may perform your own INSTALL CYCLE by selecting it in the set prefs feature and then following the screen prompts.

Page 29
Image 29
Electrolux 137023200 A manual Setting Preferences, con’t, Install Cycle, Operating User Interface Features