Problem

Possible cause

Remedy

Washing has not been

Only a few large items of

Always load the drum as full

as possible. Mix large and

spun.

washing in the drum.

small items.

 

 

 

The screw connection on the

Screw the inlet hose in

 

inlet hose is leaking.

firmly.

 

The drainage hose is leaking.

Replace drain hose.

Water is leaking out

The drain pump cover is not

Close the cover properly.

from under the

closed properly.

 

washing machine.

Washing was caught in the

Load washing carefully for

 

 

door.

the next wash.

 

Emergency drain hose is

Close off emergency drain

 

leaking.

hose properly.

Softener was not

The conditioner insert is not

 

washed in. w

Clean the detergent

correctly set into the

compartment for

dispenser drawer, insert the

additive compartment or is

conditioners is filled

conditioner insert firmly.

blocked.

with water.

 

 

 

Washing is heavily

There may have been too

 

much washing in the

Observe maximum loads.

creased.

machine.

 

 

 

The door cannot be

 

 

opened when the

The door is locked for safety

Wait until the O symbol

appliance is switched

reasons.

appears.

on. The v symbol

 

 

appears in the display.

 

 

 

 

The programme will continue

 

Power cut.

when the power cut is over.

The display goes out

To remove washing:

For safety reasons, the door

while a wash cycle is

will remain locked for

If water can be seen in the

running.

approx. 4 minutes.

appliance, before opening

 

 

 

the door, first perform an

 

 

emergency drain.

The background

 

 

illumination of the

The washing machine is in

 

display has gone out

Press any key.

even though the

stand-by mode.

 

appliance is switched

 

 

on.

 

 

 

 

 

30

Page 30
Image 30
Electrolux 1620 manual Only a few large items