Installation
Water inlet (cold water connection only)
Connect the hose to a tap with a 3/4” thread. Installation should comply with local water authority and building regulations’ require- ments.
The inlet hose is provided with a water stop | A |
device, which protects against damage | |
caused by water leaks in the hose which |
|
could develop due to natural ageing of the |
|
hose. This fault is shown by a red sector in | P0352 |
the window “A”. Should this occur, turn the |
|
water tap off and refer to your Service Force |
|
Centre to replace the hose. |
|
Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
Water drainage
This appliance is designed to be permanent- ly plumbed into your home's drainage sys- tem using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.
P1074
“U” piece supplied
P1199
38 mm (11.2”)
standpipe diameter
30 cm (12")
52
