Installation

When discharging into a

3 pin

 

standpipe ensure that the top

 

 

of the standpipe is no more

 

 

than 90 cm (35.4'') and no less

 

 

than 60 cm (23.6'') above

 

(35.4”)

60 cm (23.6”)

Max. 90 cm

floor level.

The drain hose may be extend-

Min.

 

 

 

ed to a maximum of 4 metres.

 

 

An additional drain hose and

 

 

joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

Push the drain hose

Loop

onto the spigot and

 

secure with a clip if

 

required, ensure a

 

loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.

The drain hose may be extended to a maximum of 4 metres. An addition- al drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.

If you intend the drain hose from the machine to empty into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U -Piece” supplied.

Important

Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

53

Page 53
Image 53
Electrolux 16820 manual Onto a sink outlet spigot