Electrolux 2020 D 2 1 1

5. Fix the round eyelet screws provided tightly into

the holes (1).

6. Fix bracket (S) to the fan assembly.

7. The hood is supplied in the recirculation mode,

with the recirculation grille (G) fitted over the outlet

in the top of the fan assembly ready for use.

8. Insert the 4.2x44.4mm screws to be used for

fixing the fan assembly into the rawl plugs and

tighten about two thirds. Lower the fan assembly

and chimney onto the fixing bracket (S). Ensuring

the screws locate into the fixing bracket, than

tighten the screws fully.

Installation with the air outlet turned

towards the wall:

1. Draw a vertical line on the wall from the centre of

the cooking appliance, using a spirit level and

marking pen. This is to ensure the correct vertical

alignment of the appliance.

2. Using the cardboard template provided mark the

hole positions (1) on the wall 100mm either side

of the vertical line ensuring they are level and

that the distance between the lowest point of the

hood and the cooking appliance beneath meet

the clearance requirements quoted in the

paragraph titled ‘Clearance Heights’.

3. Using the cardboard template mark the hole

positions (to be used for fixing the chimney)

30mm either side of the vertical line. The holes

must be drilled at a distance of (X) from the

horizontal line running through the centre of the

canopy fixing holes (1), which is calculated by

measuring the lenght of the chimney required for

the installation plus 15mm to equal (Z) as

illustrated opposite.

4. Using a 8mm masonry bit, drill the fixing holes

for the canopy and the fan assembly and insert

the rawl plugs provided ready for the fixing

screws.

INSTALLING INSTRUCTIONS

S

S07_11

S07_23

G

ø120

ø150

100 100 ø 8

650

S07_05

21 1