Electrolux 2170-4 operating instructions Prior to Initial Start-Up, Cold accumulation block

Cold accumulation block

There is one cold accumulation block in the freezer tray.

Refer to the section “Prior to Initial Start–Up” concerning freezing of the cold accumulation block.

3In the event of a power failure or malfunction, the cold accumulation block will increase the hold over period by several hours, providing

it is placed in the uppermost drawer, at the front, above the frozen food.

You can also use the cold accumulation block in a cool bag.

Prior to Initial Start–Up

1Before connecting the appliance to the mains and putting it into ope- ration for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 4 hours before putting it into operation. This is necessary to allow the refrigerant to flow back into the compressor. Otherwise the compressor may be damaged.

0Please clean the appliance interior and all accessories prior to initial start-up (see section: “Maintenance and Cleaning”).

0Remove the cold accumulation block from the appliance.

0Only put the cold accumulation block to freeze in the top compartment after the optimal storage temperature of –18 °C has been reached.

0After 24 hours place the cold accumulation block in the uppermost compartment, at the front, above the frozen food.

0Re-freeze the thawed cold accumulation block in the same way, e. g. after cleaning the appliance.

16 818 14 33-00/7