Troubleshooting 11
Before You Call for Service
If the appliance appears to be malfunctioning, read through this manual first. If the problem persists, check the Troubleshooting Guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call. Some remedies listed in the Troubleshooting Guide are very complex. Consulting or contracting a qualified service technician may be necessary.
If Service is Required
Contact the dealer where you purchased the appliance if service is required. State the model and serial number and explain the problem. The model and serial number plate is located on the ceiling of your appliance.
If you do not know the name of the selling dealer or a local service company, you can check online at www. electroluxicon.com, or call
warning
ELECTROCUTION HAZARD
NEVER attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected.
Problem |
| Possible Cause |
| Remedy |
|
|
|
|
|
Appliance not cold | • | Control set too warm | • | Adjust temperature colder. See “Adjusting the |
enough |
|
|
| Temperature” in the |
|
|
|
| section. Allow 24 hours for temperature to stabilize. |
| • | Airflow to front grille | • Airflow must not be obstructed to front grille. See | |
|
| blocked |
| “Installation” Section. |
| • | Door gasket not sealing | • | Adjust door gasket. |
|
| properly. |
|
|
|
|
|
|
|
Appliance too cold | • | Control set too cold | • | Adjust temperature warmer. See “Adjusting the |
|
|
|
| Temperature” in the |
|
|
|
| section. Allow 24 hours for temperature to stabilize. |
|
|
|
|
|
No interior light | • | Failed LED assembly | • | Contact a qualified Electrolux Service Technician. |
|
|
|
|
|
Light will not go out | • | Door switch not making | • | Check for proper door alignment. |
when door is closed |
| contact |
|
|
|
|
|
|
|
