Installation
Electrical Connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Starting up and temperature regulation
Wash the inside of the appliance with lukewarm water with a little bicar- bonate of soda added (5ml to 0,5 litre of water). Do not use soap or deter- gent as the smell may linger. Dry the appliance thoroughly.
•When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature control knob is located on the right hand side of the refrigerator compartment.
Setting “0”: Off.
Setting “1”: Hightest temperature, (warmest setting).
Setting “6”
The exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on:
Important!
The wires in the mains lead are coloured in accordance with the fol- lowing code:
Green and Yellow Earth
BlueNeutral
BrownLive
As the colours of the wires in the mains lead of this appliance may not
GREEN & YELLOW
13 AMP. FUSE
13 AMP |
BROWN
BLUE
The temperatures in the refrigerator compartment and freezer compart- ment cannot be independently regulated.
If you want to freeze fresh food rapidly, select setting “6”, ensuring that the temperature in the refrigerator compartment does not drop below 0°C. You should reset the temperature control knob to setting “3” or “4”, if this does occur.
As soon as the fresh food placed in the freezer has frozen, return the tem- perature control knob to “3” or “4”.
correspond with the coloured mark- ings identifying the terminals in your plug, proceed as follows:
D207
CORD CLAMP
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to
1.The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth symbol or coloured green and yel- low.
2.The wire coloured blue must be connected to the terminal marked “N” or coloured black.
3.The wire coloured brown must be connected to the terminal marked “L” or coloured red.
4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
Warning! A
run continuously.
If this happens, turn the temperature regulator back to a warmer setting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced.
18 | 7 |
