IBM 206 manual Setup and configuration overview, Typical operating system installation

vDetects installed hardware options and provides updated device drivers for most adapters and devices.

vProvides diskette-free installation for supported Windows operating systems.

vIncludes an online readme file with links to tips for your hardware and operating system installation.

Setup and configuration overview

When you use the ServerGuide Setup and Installation CD, you do not need setup diskettes. You can use the CD to configure any supported IBM server model. The setup program provides a list of tasks that are required to set up your server model. On a server with a ServeRAID adapter or integrated SCSI controller with RAID capabilities, you can run the SCSI RAID configuration program to create logical drives.

Note: Features and functions can vary slightly with different versions of the

ServerGuide program.

When you start the ServerGuide Setup and Installation CD, the program prompts you to complete the following tasks:

vSelect your language.

vSelect your keyboard layout and country.

vView the overview to learn about ServerGuide features.

vView the readme file to review installation tips for your operating system and adapter.

vStart the operating-system installation. You will need your operating-system CD.

Typical operating system installation

You can use the ServerGuide program to shorten your installation time. The ServerGuide program provides the device drivers that are required for your hardware and for the operating system that you are installing. This section describes a typical ServerGuide operating-system installation.

Note: Features and functions can vary slightly with different versions of the

ServerGuide program.

1.After you have completed the setup process, the operating system installation program starts. (You will need your operating-system CD to complete the installation.)

2.The ServerGuide program stores information about the server model, service processor, hard disk drive controllers, and network adapters. Then, the program checks the CD for newer device drivers. This information is stored and then passed to the operating-system installation program.

3.The ServerGuide program presents operating-system partition options that are based on your operating system selection and the installed hard disk drives.

4.The ServerGuide program prompts you to insert your operating system CD and restart the server. At this point, the installation program for the operating system takes control to complete the installation.

Installing your operating system without ServerGuide

If you have already configured the server hardware and you decide not to use the ServerGuide program to install your operating system, complete the following steps to download the latest operating-system installation instructions from the IBM Support Web page:

Chapter 2. Configuring your server 21