7.(optional), Type an identifier for the array.
8.Select Quick Int when asked for the array build method.
9.Follow the instructions on the screen to complete the configuration, and select Done to exit.
10.Restart the server.
Viewing the configuration: Complete the following steps to view information about the Serial ATA controller:
1.Start the Array Configuration Utility.
2.From the Array Configuration Utility window, select Manage Arrays.
3.Select an array and press Enter.
4.Press Esc to exit the program.
Using the SCSISelect Utility program (for SCSI RAID)
Use the SCSISelect Utility to add RAID levels 0 and 1 functionality to the SCSI controller. This utility is part of the BIOS code in your server.
The integrated SCSI RAID feature (SCSI HostRAID) comes disabled by default. You must enable the SCSI RAID feature and install the device drivers before you can use it. The SCSI RAID configuration utilities, device drivers, and information are available on the IBM
Enabling the SCSI HostRAID feature
Complete the following steps to enable the SCSI RAID feature:
1.Turn on the server and watch the monitor screen.
2.When the message Press <CTRL><A> for SCSISelect Utility appears, press Ctrl+A. If you have set a supervisor password, you are prompted to type the password.
3.Use the arrow keys to select the channel for which you want to change settings and press Enter.
4.Select Configure/View SCSI Controller Setting; then, select HostRAID.
5.Select Enabled.
6.Press Esc; then, select Yes to save the changes.
Using the SCSI HostRAID feature
The instructions in this section describe how to access the SCSI RAID feature from the SCSISelect Utility program and perform an initial RAID
See the documentation on the IBM
Configuring the controller: Complete the following steps to use the SCSI
HostRAID feature to configure a RAID
1.From the SCSISelect main menu, select Configure/View HostRAID Settings.
2.From the list of ready drives, type C to create an array.
3.Select
