WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
Important Notes to the Installer
1.Read all instructions contained in these installation instructions before installing appliance.
2.Remove all packing material from appliance before connecting the electrical supply.
3.Observe all governing codes and ordinances.
4.Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions for future reference.
IMPORTANT SAFETY INSTRUCTIONS
•Be sure your appliance is installed and plugged into a 120 Volt grounded outlet.
•This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No.
Tools You Will Need
Phillips® Screwdriver
Pencil
Ruler or Tape Measure and
Hand Saw or Saber Saw
Spirit Level
Warm & Serve Drawer Installation
1.Locate the 2
c/c 25 5/16"
(64,3 cm)
Use screws |
|
supplied to attach |
|
drawer to front of | Figure 2 |
cabinet. |
|
Electrical connection
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded.
Where a standard
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
24" (61 cm) Max.
23 5/8" (60 cm) Min.
c/c 12 21/32" |
|
(32,2 cm) | Figure 1 |
2.Slide drawer into cutout opening until front frame of drawer is flush against cabinet. Be careful not to pinch electrical cord.
3.Remove the drawer as instructed in the Use & Care Guide and secure drawer housing to cabinet using the
3
4.The 60" (152,4 cm) appliance power cord can now be connected into the 120 Volt outlet.
5.Proceed with mounting
Disconnect electrical supply cord from wall receptacle before servicing cooktop.
Preferred Method |
| |
Grounding type | Do not, under any | |
circumstances, cut, | ||
wall receptacle | ||
remove, or bypass | ||
| ||
| the grounding | |
| prong. |
Power supply cord with
2