8
CAST IRON STOVE AND
Installing Optional Blower Accessory
CAST IRON STOVE AND
Continued
INSTALLING OPTIONAL BLOWER
ACCESSORY
NOTICE: If installing blower in an existing stove burner system with gas connections, shut off gas supply and disconnect heater from gas supply. Con- tact a qualified service person to do this.
INSTALLING THE BLOWER
1.Remove 4 hex screws securing rear cover to back of stove body (see Figure 16).
2.Separate bottom cover from rear cover by loosening the 8 mounting screws (see Figure 16).
3.Align the holes in the top mounting tabs of blower with the holes in wall of rear cover. Using the 4 screws provided, mount blower and tighten screws securely (see Figure 17).
4.Thermostat Blower Only: Attach thermal switch and bracket to inside rear cover wall with two hex head screws provided as shown in Figure 17. After securing bracket to rear cover, care- fully bend along existing bend line on bracket to almost a 90° angle (see Figure 17). This will allow thermal switch to be positioned against stove rear wall and sense temperature when in operating mode.
5.Place speed control on left inside of rear cover and push the plastic control shaft through opening (see Figure 17).
6.While supporting speed control, secure control shaft with lock nut by pushing and turning lock nut with pliers clockwise un- til tight against the side of rear cover. Place control knob pro- vided onto shaft.
| Control | TOP VIEW |
|
| |
| Shaft |
|
Blower | Speed |
|
Control |
| |
Control Locknut |
| |
|
| |
Knob |
|
|
Hex Screws 
Stove Body
Rear Cover
Mounting
Screws
Hex
Screws
Thermal |
Switch and |
Bracket |
Screws
Mounting
Screws
Bottom Cover | Mounting |
Screws |
Mounting
Holes
Blower |
|
Assembly | Mounting Holes |
Figure 17 - Blower Assembly, Speed Control, and Thermal Switch Locations
Figure 16 - Removing Rear Cover and Bottom Cover from Stove
Body
For
.
.com
