Continued, Removing Front Surround Panel, Amity Models

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly (Cont.)

Installing Direct-Vent Burner System Into Stove Body

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

12.Check general catch bolt alignment with door claw. Make fi- nal adjustment and door leveling after stove is in normal stand- ing position.

13.Carefully lift stove back up on its four attached legs.

Removing Front Surround Panel

Remove 2 bolts from bottom of stove and set aside. Remove bolt from the top of the stove to remove the front panel assembly (see Figure 13).

Stove	Bolt
Body

Front

Assembly

Front	Screws	Screw with
Surround		Washer
Plate
Screw with
Washer		Screen
Screen
		Front Surround
		Plate and
Front Plate		Doors
Amity™ Model		Oxford™ and Victor Hearth™
		Model

Figure 14 - Removing Screen from Front Assembly

INSTALLING DIRECT-VENT BURNER SYSTEM INTO STOVE BODY

1.Carefully lift burner system and place into stove body from the rear of stove.

2.Place the left and right grate tops into the top of stove body. Dis- card center grate top of stove and replace with center grate top provided with burner system.

Figure 13 - Removing Front Assembly (Oxford™ Model Shown)

Removing Screen (Optional)

Amity Models

1.	Lay the front panel assembly face down on a protected sur-
	face. Remove the two screws that hold the front plate onto the
	front surround plate (see Figure 14). Save these screws.
2.	Remove the screws and washers that hold the screen onto the
	front surround plate. Discard these screws, washers, and screen
	(see Figure 14).
3.	Replace the two screws from step 1 to reassemble the front

Center Top Grate (Included with Burner System)

Left Top

Grate

Right Top Grate

plate and the front surround plate. Set this assembly aside un-

til burner system has been installed, logs have been placed

inside of burner system, and glass door to burner system insert

has been replaced.

Oxford or Victor Hearth Models

1.Lay the front panel assembly face down on a protected sur- face. Remove the screws and washers that hold the screen onto the front surround plate. Discard these screws, washers, and screen (see Figure 14).

2.Set this assembly aside until burner system has been installed, logs have been placed inside of burner system, and glass door to burner system insert has been replaced.

Burner

System

Cast Iron

Stove Body

Figure 15 - Installing Burner System Into Cast Iron Stove Body

For morevisit www..com