CAST IRON STOVE AND
Installing Optional Blower Accessory (Cont.)
Installing Rear Cover
9
CAST IRON STOVE AND
Continued
7.Place the green ground wire between the bottom hole on the blower assembly and the hex screw and tighten (see Figure 18).
8.Connect the blue wire on the blower assembly to one side of the thermal switch (see Figure 18).
9.Connect the black wire to the other side of the thermal switch (see Figure 18).
10.Connect the white wire to the other terminal on the blower mo- tor assembly (see Figure 18). Make sure the thermal switch has been properly installed to fit against back of fireplace insert af- ter the rear cover assembly has been reinstalled.
11.Make sure all wire connections to terminals on blower motor and thermal switch are securely attached and that the screw retaining the green ground wire is tight.
12.Check to make sure that the power cord is completely clear of the blower wheel and that there are no foreign objects in blower wheel.
13.Peel off the backing paper and stick the supplied wiring dia- gram decal on the inside of rear cover as shown (see Figure 18).
WARNING: Never touch the blower wheel while in operation.
14.Reattach bottom cover to rear cover with 8 screws (see Figure 16, page 8). Make sure that you don’t pinch any wires during reassembly. Route power cord through plastic bushing in bot- tom of rear cover.
WARNING: Failure to position the parts in accor- dance with supplied diagrams or failure to use only parts specifically approved with this heater may result in damage or personal injury.
INSTALLING REAR COVER
1.Place rear cover behind stove body. Rear cover will rest on the bottom ledge of the stove body.
2.Using hex screws provided, attach rear cover to back of stove body. See Figure 19. IMPORTANT: This rear cover must be securely in place before venting pipes are installed.
3.Open lower door panel. The valve is attached to the underside of the burner system assembly.
4.Connect or reconnect gas supply, see Connecting Stove/Burner System to Gas Supply on page 21.
WARNING: A qualified installer or service per-
Speed
Control
Black
Wire
Thermal
Switch
Blue Wire
Power Cord (Route Through
Plastic Bushing in Bottom
Cover When Assembled)
Wiring
Diagram
Decal
White
Wire
son must connect fireplace to gas supply. Follow all local codes.
Hex Screws
Rear Cover (Shown with
Screw
Green Ground Wire
Blower
Power
Cord
Optional Blower)
Figure 18 - Blower Wiring Layout (Thermostat Blower Shown)
Figure 19 - Installing Rear Cover (Shown with Optional Blower
Accessory)
For more
visit www.
.com
