Electrolux 60 - 70 Series HOW TO USE (continued) HOW TO MAINTAIN

Pull the crevice tool out of the base of the cleaner.

Place the crevice tool on the end of the hose.

When cleaning is completed, store crevice tool back

in the base of the cleaner and replace the hose in the

hose adapter on the cleaner.

CAUTION: Moving brush roll, power switch should

be in suction only position when using

hose.

1Pull the hose from hose adaptor on cleaner.

HOW TO USE (continued) HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to

routine maintenance. To avoid unnecessary service calls,

check the hose, dust cup and dust cup lter often. Clear a

clogged hose, empty the dust cup if it is full, and clean the

dust cup lter when it is dirty.

CAUTION: Turn off the po wer switch and unpl ug the

electrical cord before emptying the dust cup

or cleaning the dust cup lter.

CAUTION: Do not use the cleaner without the dust cup

lter properly installed. This can damage the

cleaner.

Hint: Some ne particles can restrict airow very quickly

and wil l decrease performance even before the

dust container appears full. For that reason, when

vacuuming carpet fresheners or cleaners, powder,

plaster dust or similar ne substances, the dust

cup and lter may need cleaning more often.

Open

Cup

Pull back on the power switch to the “open cup” position

and lift dust cup away from cleaner.

Remove dust cup and empty.

The dust cup lter can be cleaned by brushing off over

a waste container. Do not allow to get wet.

The dust cup can be rinsed under running water and

completely dried before replacing on cleaner. We do

not recommend putting it in a dishwasher.

Replace dust cup lter in dust cup.

Put bottom edge of dust cup in cleaner as shown above

and rotate down against cleaner rmly. Dust cup latch

will automatically lock.