What to do if...

Remedying small malfunctions

If the acoustic signal is activated, warning tones sound if there are faults.

If one of the following fault codes is displayed in the multi-display during operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Abort the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code.

Malfunction

Possible cause

Remedy

 

Water tap is blocked with

Check the water tap and

 

limescale or faulty.

have it repaired if necessary.

 

The tap is turned off.

Turn the tap on.

1 short warning tone

The filter (where present) in

Clean the filter in the

continuously repeated can

the threaded hose fitting

threaded hose fitting.

be heard,

on the tap is blocked.

 

the cycle indicator for the

 

 

 

Press the button for the

selected dishwashing cycle

 

 

commenced dishwashing

is flashing:

 

 

cycle;

fault code Å 10 is dis-

Filters in the base of the

then abort the dishwashing

played in the multi-dis-

dishwasher compartment

cycle (see section: Starting a

play:

are blocked.

dishwashing cycle);

(Problems with water in-

 

 

clean filters (see section:

let)

 

 

Cleaning the filters).

 

 

 

Water inlet hose

Check the position of the

 

has not been correctly posi-

 

hose.

 

tioned.

 

24