Water hardness Water hardness setting
mg/l ppm mmol/l manually electronically
400 - 509 400 - 509 4,0 - 5,0 2 6
330 - 399 330 - 399 3,3 - 3,9 2 5
260 - 329 260 - 329 2,6 - 3,2 1 4
190 - 259 190 - 259 1,9 - 2,5 1 3
70 - 189 70 - 189 0,7 - 1,8 1 2
< 70 < 70 < 0,7 11
1)
1) No use of salt required.
You must set the water softener manually and electronically.
Manual adjustment
The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The dishwasher is factory set at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights of function buttons
A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function buttons B and C go off.
– The indicator light for function button A continues to flash.
– The digital display shows the current level.
– You can hear an audible signal.
Example: digital display shows / 5 intermittent audible signals = level 5.
6. Press the function button A one time to increase the water softener level by one step.
7. Continue pressing function button A until the desired water softener level is achieved.
8. Press the on/off button to save the operation.
Setting the water softener 11