4. Do not tilt the appliance during transport.
WHAT TO DO IF…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. Refer to following
charts. If you cannot find a solution to the problem yourself, contact your dealer or the
Customer Care Centre.
WARNING!
Switch the appliance off before you do the suggested corrective actions.
Fault code and malfunction Possible cause and solution
intermittent audible signal,
the digital display shows
The appliance does not fill with wa-
ter
The water tap is blocked or restricted with limescale.
Clean the water tap.
The water tap is closed.
Open the water tap.
The filter in the water inlet hose is blocked.
Clean the filter.
The installation of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
intermittent audible signal,
the digital display shows
The appliance will not drain
There is a blockage in the sink spigot.
Clean the sink spigot.
The installation of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
intermittent audible signal,
the digital display shows
The anti-flood device operates
Close the water tap and contact your Customer Care Cen-
tre.
The program does not start The appliance door is not closed.
Close the door.
Mains plug is not connected.
Plug-in appliance to the mains.
The fuse has blown out in the household fuse box.
Replace the fuse.
Delay start is set.
Cancel the delay start to start the program immediately.
After the check, switch on the appliance. The program continues from the point of inter-
ruption. If the malfunction shows again, contact your Customer Care Centre.
If the display shows a fault code, not described in the chart, contact your Customer Care
Centre.
These data are necessary to help you quickly and correctly:
Model (Mod.)
Product number (PNC)
28 What to do if…