2. Use the supplied screws to secure the
appliance in position (upwards or side-
ways). Make sure the screws are tight-
ened.

Custom made kick-panel

For integrated appliances and full-stainless-steel door appliances.
We recommend that you make a custom made
kick-panel that aligns your kitchen cabinets.
• A notched continuous panel is necessary to pre-
vent door swing interference and to keep kick-
panel alignment with adjacent units.
• Cut a notch in the kick-panel sufficient to let
the door swing freely under the appliance.
• Make a check for interference. Open and close
the door slowly. If the door touches the kick-
panel, trim to prevent interference.
• Attach the kick-panel to adjacent cabinets so
that if service is necessary you can remove it.
WATER CONNECTION

Water inlet hose

Connect the appliance to a cold water supply.
Connect the inlet hose to a water tap with an external BSP thread spout of 3/4”.
CAUTION!
Always use new hoses when you connect the appliance to the water mains. Old hoses must
not be used. The water inlet hose must be examined at an interval of twelve months for
deterioration and replaced if necessary.
The water pressure must be in the limits (refer to 'Technical data'). Make sure that the local
water authority gives you the average mains pressure in your area.
32 Water connection