Operating Instructions
What to do if...
Trouble Shooting
If the appliance is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre.
Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
• If the fault code E10, E20 or E40 is shown in
the
After clearing the fault, press the START/ PAUSE button. If the fault code is displayed again, contact your local AEG Service Force Centre.
•For all other faults displayed in the
Problem | Possible Cause | Remedy | |
| The mains plug is not | Plug in the mains plug. | |
| plugged in. | ||
|
| ||
| The house fuse has blown. | Replace the fuse. | |
The washing machine | The door is not correctly | Close the door; The lock must | |
does not work. | |||
closed. | engage audibly. | ||
| |||
| START/PAUSE button not | Keep the START/PAUSE but- | |
| ton pressed until the pro- | ||
| pressed long enough. | ||
| gram begins. | ||
|
| ||
|
|
| |
|
| Cancel the child safety fea- | |
Door cannot be closed. | The child safety feature is set | ture (see Section "Child | |
|
| Safety Feature“). | |
The fault code E40 | The door is not correctly | Close the door correctly. | |
appears. The display | |||
closed. | Start the program again. | ||
MAIN WASH flashes. | |||
|
| ||
|
|
| |
No water flows. | Water tap is closed. | Open the water tap. | |
| Close the water tap. Unscrew | ||
Fault code E10 |
| ||
appears. The display | Filter in screw connection of | the hose from the tap, | |
the inlet hose is blocked. | remove the filter and clean | ||
RINSE + flashes | |||
| under running water | ||
|
| ||
|
|
|
30
