Installation Location
This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rat- ing plate, which is located on the inside left of the appliance.
The following table shows which ambient temperature is correct for each climate classification.
Climate classification |
| for an ambient temperature of |
|
|
|
|
|
|
SN |
| +10 to +32 °C |
|
|
|
N |
| +16 to +32 °C |
|
|
|
The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem- peratures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.
For
Your appliance needs air
For safety reasons, minimum ventila- tion must be as shown Fig.
Attention: keep ventilation openings clear of obstruction;
50 mm | min. |
200 cm2 | |
| min. |
| 200 cm2 |
D567 |
|
Reversing the door
The side the door opens can be changed from the right side (factory adjust- ment) to the left side, if the installation site requires.
Warning! When changing the side the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand.
19
