electrolux 9

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

)To light a burner:

z turn the relevant knob anticlockwise to

maximum position (), then push it down to ignite the burner.

Only for models EHG 641, EHG 6412, EHG 6832

z Upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (Fig. 1 - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.

z Then adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in this case, approach the burner with a flame,

Triple Crown Burner (only

in mod. EHG 6832)

A

B

D

C

A - Burner cap

Fig. 1

B - Burner crown

 

C - Ignition electrode

 

D - Thermocouple (only in models EHG 641, EHG 6412, EHG 6832)

Page 9
Image 9
Electrolux EHG 6402 Operation, Hob burners control knobs, Lighting the burners, Only for models EHG 641, EHG 6412, EHG