Building In
Building over a cupboard or drawer
If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.
It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.
1 | ON/OFF SWITCH |
| |
FLEX |
|
OUTLET |
|
FO 0763 |
|
2 | ON/OFF SWITCH |
| |
| FLEX |
| OUTLET |
FO 0764 |
|
3 |
| 30 | |
|
| ||
| a | min | |
60 | 20 | ||
| |||
| b |
|
FO 1013
Dimensions are given in mm.
Building over a kitchen unit with door
Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3.
The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.
Fitting the hob to the worktop
Before fitting the hob into the cut out, an adhesive sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.
☞1) Place the sealing gasket all around the edge of the cut out.
2)Place the hob into the cut out and secure it by means of the relevant fixing clamps and screws, as shown in the diagram.
FO 0402
a
a)Sealing gasket
15
