Electrolux EHG 7812, EHG 7822 manual Operation, Hob burners control knobs, Lighting the burners

10electrolux

Operation

Hob burners control knobs

The symbols on the knobs mean that :

#there is no gas supply

there is maximum gas supply there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

!To light a burner:

# push in the relevant control knob and turn it anticlockwise to maximum position (), to ignite the burner.

Only for model EHG 7822

#Upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (Fig. 1 - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.

#Then adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

In the absence of electricity, ignition can occur without the electrical device; in this case, approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the “maximum” position.

Triple Crown Burner
	A
	B
	D
C
A - Burner cap	Fig. 1

B - Burner crown

C - Ignition electrode

D - Thermocouple (only in model EHG 7822)

If the control knobs become difficult to turn, please contact your local Service Force Centre.