22electrolux
Fitting the Hob into the Worktop
Carry out the building in of the hob as follows:
1. place the seals supplied with the hob on the front edge of the cut out. Then, place them at 86 mm from the side edges and at 10
mmfrom the rear edge, as shown in the diagram, taking
care that the seals meet without overlapping.
2. Place the hob in the cut out, taking care that it is centred.
3. Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram). When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
Seal
