|
| what to do if … electrolux 27 |
What to do if … |
|
|
|
|
|
Problem | Possible cause | Remedy |
|
|
|
The cooking zones cannot be | More than 10 seconds have | Switch the appliance on again. |
switched on or are not operat- | passed since the appliance |
|
ing | was switched on |
|
| The child safety device is | Deactivate child safety device |
| switched on | (See the section “Child safety |
|
| device”) |
| Several sensor fields were | Only touch one sensor field |
| touched at the same time |
|
| Automatic | Remove any objects (pan, |
| triggered | cloths, etc.) that are lying on |
|
| the control panel. Switch ap- |
|
| pliance on again |
| There is water on the control | Wipe the control panel |
| panel or the control panel is |
|
| covered with fat splashes |
|
Acoustic signal sounds when | The control panel is wholly or | Remove objects. |
appliance is switched off | partly covered by objects. |
|
| There is water on the control | Wipe the control panel |
| panel or the control panel is |
|
| covered with fat splashes |
|
The residual heat indicator is | The cooking zone was only on | If the cooking zone is sup- |
not displaying anything | for a short time and is therefore | posed to be hot, call the Cus- |
| not hot | tomer Service Department. |
The signal sounds and the ap- | Something is covering the On/ | Do not put any objects on the |
pliance turns itself on, then off | Off sensor field | control panel |
again after 5 seconds. After |
|
|
another 5 seconds the signal |
|
|
sounds again. |
|
|
lights up | Automatic | Switch off the cooking zone. |
| triggered | Switch the cooking zone on |
|
| again |
and a number is displayed | Electronics fault | Disconnect appliance from the |
|
| electrical supply for a few min- |
|
| utes. (Take the fuse out of the |
|
| house’s wiring system.) |
|
| If you still see and a number |
|
| after switching the appliance |
|
| back on, call the Customer |
|
| Service Department |
|
|
|