Electrolux EK 5701 manual Replacement of grill burner nozzle

Replacement of grill burner nozzle

To replace the grill burner nozzle, follow this procedure:

a)remove the screws (see fig.);

b)take the grill burner out;

c)with a socket spanner 7 unscrew and remove the nozzle, situated in the top of the oven, and replace it with the proper one (see Table at page 21);

d)undo the fixing screw of the metal ring of primary air adjustment and adjust the relevant opening (see diagram);

e)reassemble the burner following the same pro- cedure backwards.

Natural gas adjustment: full opening width

LPG adjustment: opening 10 mm wide

Minimum level adjustment of gas oven burner

After setting the oven on maximum temperature with door closed for about 10 minutes, turn the knob on minimum.

To reach the thermostat by-pass screw and adjust the minimum level, act as follows:

–take out the knobs;

–remove the front panel;

–in case of conversion from natural gas to LPG, tightly screw the by-pass screw of thermostat (see fig.);

–to convert from LPG to natural gas, unscrew the by-pass screw, until a regular small flame is reached.

–finally check that turning quickly the tap from maximum position to minimum position, the flame does not go out;

–reassemble the front panel and the knobs. The oven burner does not need any primary air regulation.

FO 1061

27