Cleaning your Appliance
Painted & Plastic parts
●Only use a clean cloth wrung out in hot soapy water.
●Do not use abrasive cleaners, such as “Cif”, wire or nylon cleaning pads on these parts.
Stainless steel & Aluminium surfaces
●Only use a clean cloth wrung out in hot soapy water, and dry with a soft cloth.
●Stubborn marks can be removed using a stainless steel cleaner. Supplies can be purchased from the Customer Care Centre.
●Sharp objects can mark the surface of stainless steel, but will become less noticeable with time.
●Wipe any spillage immediately, taking care to avoid burn- ing your hands.
●Some foods are corrosive eg; vinegar, fruit juices and especially salt - they can mark or damage the metal if they are left on the surface.
Enamel surfaces & parts
●Clean with warm, soapy water and a clean cloth.
●Dry with a soft clean towel or cloth.
●Do not use steam cleaners.
Glass parts
●Only use a clean cloth wrung out in hot soapy water, or a specialist glass cleaner.
●Rinse away any excess cleaner and dry with a soft cloth.
●Do not use abrasives or polishes as they will scratch and damage the glass.
●The inner door glass panel can be removed for cleaning but it must be replaced the right way up. If there is any writing on the glass, you must be able to read it clearly when the cavity doors are open.
●Always make sure that the glass is pushed fully into the Stop position.
●To remove the glass panel, open the door wide, hold the top and bottom edges and slide out.
●Warning: Do not operate the appliance without the glass panel correctly fitted.
! | Always allow your |
appliance to cool | |
| down, and switch off |
| the electricity before |
| you clean any part of |
| it. |
|
|
i | Take extra care when |
| cleaning over symbols |
| on fascia panels, |
| excessive cleaning can |
| lead to the symbols |
| fading. |
|
|
iBaby oil can be used to restore stainless steel finishes - but only use a few drops. Do not use cooking oils as they can contain salts which will damage the metal.
i Do not use: undiluted bleaches, products containing chlorides or abrasive cleaners on aluminium or stainless steel, they can damage the appliance.
Glass door panels
For your safety, glass door panels are made of toughened glass. This ensures that, in the unlikely event that a panel breaks, it does so into small fragments to minimise the risk of injury.
Please take care when handling, using or cleaning all glass panels, as any damage to the surfaces or edges may result in the glass breaking without warning or apparent cause at a later date.
Should any glass panel be damaged, we strongly recommend that it is replaced immediately.
21
