After reinserting the inner pane, adjust
the retainer “C”, then:
AC
Fig. 5: insert the right end of the perfo-
rated aluminium plate ”A” into the recess
in the retainer “C”.
BA
Fig. 6: Then insert the left end of the per-
forated aluminium plate ”A” into the re-
cess in the retainer “B”.
Insert the retainer “B” at this point and
check that everything is securely fas-
tened and firm.
Appliances in stainless steel or
aluminium
We recommend you only clean the oven
door with a wet sponge and then dry it
afterwards with a soft cloth. Never use
scourers, acids or harsh abrasives, as
these can damage the surface. Clean
the panel with the same care.
DO NOT clean the oven door while
the glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes chipped
or has deep scratches, the glass will be
weakened and must be replaced to pre-
vent the possibility of the panel shatter-
ing. Contact your local Service Centre
who will be pleased to advise further.
If necessary, it is possible to reverse
the oven door. This operation should
be carried out by authorized person-
nel ONLY.
Customers are recommended not to
carry out this operation themselves.
This will be a chargeable visit.
Replacing The Oven Light
Disconnect the appliance.
If the oven bulb needs replacing, it must
comply with the following specifications:
– Electric power: 15 W/25 W,
– Electric rate: 230 V (50 Hz),
– Resistant to temperatures of 300°C,
– Connection type: E14.
These bulbs are available from your local
Service Force Centre.
To replace the faulty bulb:
24 electrolux cleaning and maintenance