Electrolux ERB34257W, ERB39251W Location, Electrical connection, Removing the transport support

Climate	Ambient temperature
class
SN	+10°C to + 32°C

N+16°C to + 32°C

ST +16°C to + 38°C

T+16°C to + 43°C

Location

To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 40

mm. Ideally, however, the appliance should not be positioned below overhanging wall units.

If the cabinet is placed in a corner and the side with the hinges facing the wall, the dis- tance between the wall and the cabinet must be at least 30 mm to allow the door to open enough so that the equipment can be re- moved.

The ventilation space can be:

• directly above the appliance

• behind and above the top cupboard.

In this case, the space behind the top cup- board must be at least 50 mm deep.

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor- respond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power sup-

electrolux 13

ply socket is not earthed, connect the appli- ance to a separate earth in compliance with current regulations, consulting a qualified electrician.

The manufacturer declines all responsibility if the above safety precautions are not ob- served.

This appliance complies with the E.E.C. Di- rectives.

Removing the transport support

Your appliance is equipped with transport support to secure the door during transpor- tation.

To remove them do these steps:

1.Open the door.

2.Remove the transport support from the door sides.

3.Remove the transport support from the lower hinge (some models).

Important! Some models are fitted with a silencing pad under the cabinet. Do not remove this pad.

Removing the shelf holders

Your appliance is equipped with shelf retain- ers that make it possible to secure the shelves during transportation.

To remove them proceed as follows:

1.Move the shelf holders in the direction of the arrow (A).

2.Raise the shelf from the rear and push it forward until it is freed (B).

3.Remove the retainers (C).