Electrolux ERC3709 manual Door Reversal

Door Reversal

1.Close the appliance and disconnect the appliance from the electricity socket.

2.Remove the ventilation grille. There is a part on the grille that can be removed. Remove and reposition it on the opposite side.

3.Support the appliance on a wooden block when it is laid down. This will make it easier to grip under the appliance when returning to an upright position.

4.On the upper part of the appliance. Remove the hinge pin and replace on the other side.

5.On the lower part of the appliance.

a. Unscrew the hinge.

b. Remove the door-closing fittings from the hinge and put the hinge pin on the other side. Then attach the supplied door-closing fitting.

6.a. Remove the door-closing fitting from the bottom of the door.

b. Remove the plastic plug from the corresponding hole on the other side. Use a screwdriver to lever the plug loose. Then secure the supplied door-closing fitting.

c. Secure the lower hinge.

7.Raise the appliance and replace the ventilation grille.

8.To transfer the handle.

Unscrew the screws. Push the blanking plugs into the holes on the opposite side of the door. Fit the handle onto the opposite side by turning it one half circle. Press the supplied plastic plugs into the holes to which the handle was previously fitted.

9.Put the appliance in position. Check that the appliance is level. See the section "Positioning the appliance".

1

2

3

4

5 b

5 a

6	a	b
		c

Electrolux 818 21 42-01/1

13