Electrolux ERC3709 manual Something Not Working, To change the light bulb, Symptom Solution

To change the light bulb

The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet.

Press the spring together and pull the grille downward at the same time.

Use a bulb of the same type, E14 socket, maximum rating of 25 W.

When the appliance is not in use

Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.

If the appliance is left on, e.g. while on holiday, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.

Something Not Working

Before contacting your local Service Force Centre check the following points:

Symptom	Solution
The temperature is too high inside the	Set a lower temperature.
refrigerator.	Put food products in the right place inside the refrigerator. See
	the chapter "Temperature inside the refrigerator".
	Distribute the food products to allow cold air to circulate
	around them.
	Make sure that the door is completely closed and that the
	rubber door seal is complete and clean.
	The temperature where the cabinet is placed is not within its
	operating limits. See installation section.
It is too cold inside the refrigerator.	Set a warmer temperature.
	See the section"To start the fridge and thermostat control".
There is water on the cooling plate inside	This is normal. During automatic defrosting, frost thaws on the
the refrigerator.	cooling plate.
Water is running inside the refrigerator.	Clean the water drain and drain hole inside the refrigerator
	using a piece of flexible curtain wire.
	Food products could have been placed near the rear of the
	appliance, preventing the water from running into the drain.
Water comes out on the floor.	Place the drain hose at the back of the appliance above the
	drain bowl. See the chapter "Before use"
The compressor operates continuously.	Set a warmer temperature.
	Make sure that the door is completely closed and that the
	rubber door seal is complete and clean.
	The temperature where the cabinet is placed is not within its
	operating limits. See installation section.
The cabinet does not operate at all.	The appliance is not switched on.
Cooling or interior light does not	Power does not reach the appliance. (Try connecting another
operate. No indicator lamps light.	electrical device to the power outlet.)
	The fuse has blown.
	The power plug is not properly connected.

Electrolux 818 21 42-01/1

8