14 electrolux GB | GB |
Change of door opening direction
Should the
Following operations are to be done on the basis of figures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder off, unscrew the screws fixing the top door holder (2 pieces) and take it off according to figure.
Take the door off.
Remove the screw fixing the lower door holder and the other screw fixing the lower door holder and the foot. Then remove the door holder and the foot as shown in the Figure.
Loosen the screw fixing the foot opposite the lower door holder in order to remove the foot.
Fix the door holder and the corresponding foot on the opposite side and then the other loosened foot at the former place of the door holder as shown in the Figure.
Please make sure to place the lower foot below the door holder. The lower foot is recognizable by its 4 ribs on the
outer surface.
Fit the door to the lower door holding pin.
To fit top door holder remove plastic coverings of door holder holes carefully (e. g. with a knife) and put them on the other side.
Fix top door holder with 2 screws in the place set free being careful that the edge of the door is parallel with the side of cupboard.
Put the covering of top door holder back.
Put over the handle and the plastic nails on the other side.
In case you do not want to perform the procedures above, call the nearest