17.Remove the three caps (N) inserted in the late for the hinge screws and mount them on the opposite side;
18.Remove the washer (P) from the upper middle hinge, remove the pin and mount it on the other side by fitting the washer on the pin and positioning the whole group on the other side;
19.Mount the door again. Leave the door open and fasten the upper middle hinge with the two screws in the inner holes.
20.Close the door and tighten the third screw in the hole.
21.Unscrew the handles. Refit them on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
PR220 |
Printed on recycled paper
19
